Need a solution to add your pixels to 1/2" emt conduit? Here is one answer, these specially designed clips snap onto the emt and hold 3 bullet node pixels(1 on 3 sides of the pipe, 90 degrees from each other) by utilizing the pixel holders from my RBL adapter caps. As with my RBL adapters, I recommend sliding the pixel down vertically from the top of the holder, trying to push it in horizontally may break the arms of the clip. There is a slot on the inside of the pixel holder to allow the wiring to run close to the pipe to prevent shadowing. Additionally there is a slot to run a zip tie through, once tightened down the zip tie helps hold the clip in place to prevent it from sliding up or down or spinning. No need to glue or tape the clips in place. Zip ties are even included with each clip!!! And not the cheapo zip ties that break soon as you try to tighten them.
These are printed in white petg as it is the material I have found to hold up best outdoors over time from my own experiences.
These were designed with the Boscoyo Chromaglow tubes in mind, however they would be great for those great diy North Poles, pixel sticks, house outlines, or anywhere you need to mount pixels to 1/2" emt. If you prefer a single pixel holder for outlines or other areas, please contact me and I can change the design to fit those needs.
Check my other listings for a 2 pixel version of this clip as well as other great lightshow and fun products! Any questions please feel free to contact me!
3D printing is accomplished by printing layer by layer, slooooowly. Due to this additive layering, there may be minor imperfections that can easily be fixed if you decide to finish it into a show piece. Posted pictures in listings are always representative of final quality.
Bulk discounts available for quantities of 100 or more, message me for a quote.